Impecca ITAC10-KSA21 Betriebsanweisung Seite 36

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 50
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 35
9
11
This units increased performance characteristics result from having two rear air intakes.
It is very important that these installation instructions are followed so your unit can operate at
maximum efficiency.
If this is an existing sleeve, and there is an existing rear grille, it needs to be replaced by one that
has been shipped with the unit in the accessory kit.
FOR INCREASED EFFICIENCY,UTILIZE THE PROVIDED LOUVERED REAR PANEL
Installation of new grille provided with unit
1. Remove the existing grille.
2. Place the grille included with the new air conditioner towards the rear of the sleeve.
3. Mark through the hole positions.
4. Drill through the sleeves flanges with a 1/8 drill bit.
5. Attached the new grille with self-threading screws and washers.
6. It is VERY IMPORTANT that the grill e is placed exactly as shown below.
7.Most decorative exterior grilles may be left in place as long as the proper interior air direction grille
is installed.
LEA ATENTAMENTE-IMPORTANTE
• Las características del rendimiento incrementado de esta unidad se deben a que cuenta con dos tomas de aire en la parte poste-
rior.
• Es muy importante seguir estas instrucciones de instalación de manera que su unidad opere con una eciencia máxima
• Si se trata de una carcasa ya existente y también cuenta con una rejilla posterior necesita ser reemplazada por la que vino em-
pacada con su unidad.
PARA UNA MAYOR EFICIENCIA UTILICE EL PANEL POSTERIOR CON PERSIANAS QUE SE LE HA PROPORCIONADO.
Instalación de la nueva rejilla que vino con su unidad.
1. Retire la rejilla existente.
2. Coloque en la parte posterior de la carcasa la rejilla nueva que vino con su unidad.
3. Marque las posiciones de los oricios.
4. Perfore a través de los rebordes de la carcasa con una broca de 1/8”.
5. Fije la nueva rejilla con tornillos de auto enroscado y arandelas.
6. Es MUY IMPOTANTE que la parrilla esté colocada como se muestra más adelante.
7. Pueden dejarse en su lugar algunas parrillas decorativas exteriores siempre y cuando se instale la parrilla que
proporciona la dirección de aire adecuada.
Seitenansicht 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare